Reattaching throttle cable

[VancouverBCnsx]

I successfully cleaned the throttle body but am now at my wits end trying to reattach the end of the throttle cable. What am I missing? Any hints on getting this done would be greatly appreciated.
Thanks

Marc

 

[Si Espanol4Yes]

Open throttle partial way with your left hand. It's a hook and loop kind of attachment onto the throttle itself. Bend the cable slightly upwards, insert from the left side of the plate, and then kinda tap it right into its little cutout space. Once it's installed on to the plate, you can worry about attaching/adjusting the length.

Its hard are to explain without a picture. Kind of a pain in the ass, but doable. Good luck!

 

[solidol]

Open throttle partial way with your left hand. It's a hook and loop kind of attachment onto the throttle itself. Bend the cable slightly upwards, insert from the left side of the plate, and then kinda tap it right into its little cutout space. Once it's installed on to the plate, you can worry about attaching/adjusting the length.

Its hard are to explain without a picture. Kind of a pain in the ass, but doable. Good luck!

^ you basically want to move the locking point on the pulley to give you enough slack to slide the cable in.

 

[VancouverBCnsx]

Success!
Thanks a lot