Question: Rear Camber Kit Install. Thom Ayotte Kit.

[RYU]

Yes, I have a few sets left. I'm also planning to bring a few to NSXPO.

Rich Wong

Great! Hope you hear back from Thom.

 

[03 raw nsx]

Here is Thom's response. Regarding the pictures (he is also willing to have a discussion)

He shows the mounting point are on even plan using an angle iron. He needs to notice that one of the mounting points (front one, if I remember correctly) is at an angle not flat to his angle iron. When we project away from the car in the direction of the wheel, the mount needs to make up for the delta in more than one direction. The rear mount is flat therefore it would just move out only; the front mount requires more offset (up). In order to manufacture the pivots to be the same, both where manufactured with half the distance needed, hence one is high (front), turn the other one around and it is low (rear). Not sure how else to describe it unless I was there.

 

[Eheim]

Yes, I have a few sets left. I'm also planning to bring a few to NSXPO.

Rich Wong

Hi Rich, Would you still happen to have a Thom set for the upper rear control arms available?
Many thanks John (New Zealand)

 

[03 raw nsx]

Hi Eheim,

Sorry, I just sold the last set a couple of month ago. I think @MexiRicer was possibly going to make them.

Cheers
Rich

 

[MexiRicer]

Thank you Rich for the mention! Myself and my buddy @nsxnemo are working on a batch order of about 20 kits. I will update when they are ready!

 

[03 raw nsx]

Thank you for continuing the camber kits!
Did you guys want the sleeves?

 

[MexiRicer]

Thank you for continuing the camber kits!
Did you guys want the sleeves?

I’ll message you Rich. Thank you