Anyone know where this is supposed to go?

Joined
28 September 2004
Messages
1,742
i can seem to remember where this goes? any ideas? its about 7-8 inches long
thanks

11097DSC01400-med.JPG


11097DSC01401-med.JPG


11097DSC01402-med.JPG


thanks

marc
 
between the tranny and the block, by the oil pan!
 
I can't remember exactly, but I believe it connects the tranny and the block, on the rear side of the engine.
 
DAAAMMMNNNNN you guys are quick..i remember now, thanks
hope fully it will go back in now that i have it all together.. :(
 
Incase you need the extra info ..... 14mm bolt sideways into the Transmission and 12mm bolt up into the block. :biggrin:
 
It is on the passenger side, it runs from the right side of transmission case at 90 degrees to the centerline of the car. It is forward of and parallel to the propeller/drive shaft exiting the right side of the transmission. Look near the rear of the oil pan vertical hole bolts to the block near the motor mount, horizontal bolt goes to the transmission.

Good Luck
Bob
 
YOU DONT NEED IT!!! THATS MORE WEIGHT!!!

:-p

Its the tranny brace to the engine.... this must be installed...
 
Back
Top