Tweeter Mount

[Nick675]

Nick,
Is there anything directly under the tweeters you need to be careful of when making the hole? I was planning to use a hole saw to drill the hole for the tweeter. Wondering if I need to make a stop for the drill to insure it doesn't hit anything when it breaks through. What is the dash made of at that location?

John

Sorry for delay in my reply I am still in Brazil on Vacation. I used a hole saw. I removed the vent so that I could drill and not worry. Make sure you cut the dash first with a razor before you hole saw. There is nothing to hit once you remove the vents. I think there was about 2-3 inches of space between the vent and dash. Look back at my install and you can see better.

Good luck

Sent from my ADR6300 using Tapatalk

 

[jcsb]

Thanks Nick.

John