I don't see much talk about turbo sizing on here, it seems most just go with whatever a pre-built kit provides.
I'm trying to get a idea of what I want to use, I was thinking about a Borg Warner S300 based Turbo. I've used these on rotaries in the past and they've been fast spooling turbo's.
Here are the specs, let me know what you think.
T4 flange
Modular center/backwall
.313 dia. shaft
Compressor has 4" inlet x 3" outlet
1.0 divided turbine w/4" outlet
Small "Q" trim turbine 76mm x 68mm
Compressor is 61mm x 84mm rated 82% @ 18psi 64#/min.
FYI, my engine is unopened and I don't plan on opening it so I'd say 450 whp is the max for me.
Thanks guys!
I'm trying to get a idea of what I want to use, I was thinking about a Borg Warner S300 based Turbo. I've used these on rotaries in the past and they've been fast spooling turbo's.
Here are the specs, let me know what you think.
T4 flange
Modular center/backwall
.313 dia. shaft
Compressor has 4" inlet x 3" outlet
1.0 divided turbine w/4" outlet
Small "Q" trim turbine 76mm x 68mm
Compressor is 61mm x 84mm rated 82% @ 18psi 64#/min.
FYI, my engine is unopened and I don't plan on opening it so I'd say 450 whp is the max for me.
Thanks guys!