I couldn't sleep so I decided to run down stair and pop the lights off and went to work.
Also, I just enjoy doing lights work. However, I have no knowledge on how LED work, resistor, OHM, watts and all that work. I just know how to do it. If you ask me what resistors I used, I wouldn't be able to tell you because I don't know. lol.
Anywho, here is one side done.
to give you an idea of how bright it is: The room is about 90% dark
This photo is in the restroom where it's pitch black.
For now I'll be testing it with one strip and see if the original signal lights can be seen pass these. If not, I'll cover the the whole with LEDs and it will become both driving and signal lights.
This is just a test. I personally don't like the LED light to be seen. When I get more LEDs in, ill make it to be like how the red is in this photo:
BTW- this cost me less than 10 bucks in materials
Also, I just enjoy doing lights work. However, I have no knowledge on how LED work, resistor, OHM, watts and all that work. I just know how to do it. If you ask me what resistors I used, I wouldn't be able to tell you because I don't know. lol.
Anywho, here is one side done.
to give you an idea of how bright it is: The room is about 90% dark
This photo is in the restroom where it's pitch black.
For now I'll be testing it with one strip and see if the original signal lights can be seen pass these. If not, I'll cover the the whole with LEDs and it will become both driving and signal lights.
This is just a test. I personally don't like the LED light to be seen. When I get more LEDs in, ill make it to be like how the red is in this photo:
BTW- this cost me less than 10 bucks in materials
Last edited: