All:I did the Danoland solenoid flush procedure last night. I exercised the solenoids and 2 of them spit some debris but the others did nothing. I did hear them moving but no fluid. I removed the old fluid and replaced it. I flipped the switch on the pump and nothing happens. Does the car need to be on? What am i doing wrong? Fuses are ok. Sounds like the system was not pressurized. Help!Thanks
ABL Solenoid Flush -pump not working?
- Thread starter b757236
- Start date
The car does not need to be "on". Bypassing the relay should activate the pump. Perhaps the motor of the pump is shot. But I would just put 12V directly at the wires coming out of the motor to eliminate the (unprobable) risk of a wiring problem. Another method to activate the pump to put back pressure in the system is to start the car a drive it. Pump should activate to "recharge" the pressure.
I have been traveling. thanks for your reply. Unfortunately the car the rear tube gaskets are shot. All three spark plugs had oil on them. 2 of them where not even firing because there was so much oil in the cylinders. I will try this once i replace the gaskets.
Car is running great after gasket, tube seals, and new plugs. Where is the ABL motor/pump? Does anyone have a diagram? I want to try hooking up a 12V to see motor runs.
Thank you. Has anyone seen a diy on the motor only? I need to order one and install.
