XM radio face plate-how to remove paint?

[mandrewz]

I would like to remove the painted on 'Pioneer' from the plastic lens, any thoughts on what chemical might to this without harming the clear plastic?

 

[Soichiro]

Try Goo B Gone, WD40 or similar. You may have to sand and repaint. Good luck.

 

[ScienceofSpeed]

It is likely an enamel based paint. Sand and repaint as Mr. Honda suggests is likely required.

-- Chris

------------------
Revolutionize your NSX with ScienceofSpeed
www.ScienceofSpeed.com | [email protected] | 877-863-4520

 

[anvil]

If your intent is to remove the logo from an otherwise transparent piece of plastic I can relate that I used a 600 grit wet/dry sand paper, available at AutoZone to remove scratches on a tail light lens. To restore the transparency I used a scratch and swirl remover (Turtle Wax). You can't tell that anything ever was done to the tail light lens.

Good luck.

anvil