Just had Tein S tech lowering springs installed by Autowave.
I measured the ground clearance from the front fender and rear fender before and after, it lowered the car exactly .7inches in front, 1 inch in rear, just as advertised, not .1 inch less or more.
Ride quality is exactly the same as stock, maybe 10% stiffer, very subtle drop, hopefully once the springs fully settles it will be slightly lower, another .3 inch in front would be nice.
Here is another Tein S Tech review:
http://www.g35coupe.net/content.php?review.6
I have had these aftermarket exhaust tips for 6 months, I put the stock oval exhaust back immedaitely after test fitting as they looked really cheesy. There are two bolts connecting tips to exhaust that stick out too much, looks cheap and cheesy.
Mark at Autowave trimmed off the bolts on these exhaust tips, and cut two openings on each tip, I then connect them to the exhaust using clamps, that made them looks perfect from any angle, no bolts or clamps insight, looks just like a full exhaust, I love the new look. Thanks Mark!
This should keep me happy until I pick up the Taitec GT lightweight exhaust.
I measured the ground clearance from the front fender and rear fender before and after, it lowered the car exactly .7inches in front, 1 inch in rear, just as advertised, not .1 inch less or more.
Ride quality is exactly the same as stock, maybe 10% stiffer, very subtle drop, hopefully once the springs fully settles it will be slightly lower, another .3 inch in front would be nice.
Here is another Tein S Tech review:
http://www.g35coupe.net/content.php?review.6
I have had these aftermarket exhaust tips for 6 months, I put the stock oval exhaust back immedaitely after test fitting as they looked really cheesy. There are two bolts connecting tips to exhaust that stick out too much, looks cheap and cheesy.
Mark at Autowave trimmed off the bolts on these exhaust tips, and cut two openings on each tip, I then connect them to the exhaust using clamps, that made them looks perfect from any angle, no bolts or clamps insight, looks just like a full exhaust, I love the new look. Thanks Mark!
This should keep me happy until I pick up the Taitec GT lightweight exhaust.
Last edited: