- Joined
- 28 November 2009
- Messages
- 997
Any one else have any problems removing the end links nut?
I have searched and realize you need to use a 6mm allen key. That isn't the problem, the problem is the allen key part. Bad design.
the problem is it wobbles about too much and can't get a good hold on the allen key. I have loosened it off to a certain point and the nut is near the end but i'm concerned if i give it too much the allen key part will churn up inside and i will be in trouble.
It's so close to the end. I have used lots of WD40.
It doesnt even want to do back up again.
Is there another alternative to looking into aftermarket adjustable end links?
And i thought sway bars would be easier to fit, :O
I have searched and realize you need to use a 6mm allen key. That isn't the problem, the problem is the allen key part. Bad design.
the problem is it wobbles about too much and can't get a good hold on the allen key. I have loosened it off to a certain point and the nut is near the end but i'm concerned if i give it too much the allen key part will churn up inside and i will be in trouble.
It's so close to the end. I have used lots of WD40.
It doesnt even want to do back up again.
Is there another alternative to looking into aftermarket adjustable end links?
And i thought sway bars would be easier to fit, :O
