A previous owner installed a MOMO hub and steering wheel on my 1991. They simply removed the SRS Unit Reel Assembly and cut the black flat ribbon cable under the column that would normally run to the Reel Assy. :frown: Therefore, I don't have the three separate connectors to wire in buttons for the cruise, horn and to jumper the SRS light to turn it off. Upon discovering this, I simply removed the SRS bulb from the instrument panel, but I feel like that's cheating. Plus I want a horn and cruise control. So the Question:
Can anyone tell me the what wires I would use at the yellow connector where it transitions from about 6-7 gray wires into the flat ribbon cable? I know one of them was hot 12V, but I have no idea which of the wires was for the airbag, cruise or horn. I think if I can figure this out, then I won't have to buy a whole new reel assy. TIA
David
[email protected]
Can anyone tell me the what wires I would use at the yellow connector where it transitions from about 6-7 gray wires into the flat ribbon cable? I know one of them was hot 12V, but I have no idea which of the wires was for the airbag, cruise or horn. I think if I can figure this out, then I won't have to buy a whole new reel assy. TIA
David
[email protected]
