Removing/installing rear studs?

[davidf]

I recently purchased a set of Ichiba 10mm rear hubcentric spacers to hopefully clear a BBK, but now realize the hub assm. must be pulled to remove/install the studs.:frown: Am I looking at a big time consuming job? Is it a special hub puller or can I pick up one somewhere? Thank's.:smile:

 

[ChopsJazz]

David, there are a couple recent threads about stud breakage and replacement. I'll do a quick search and see what I can dig up.

 

[ChopsJazz]

Here ya go.

http://www.nsxprime.com/forums/showthread.php?t=118741&highlight=studs
http://www.nsxprime.com/forums/showthread.php?t=116911

and here's a good DIY:

http://www.danoland.com/nsxgarage/fronthub/stud/studs.htm

HTH

 

[davidf]

Thanks, I attempted the job this past weekend by removing caliper/rotor and the hub "nut" but it would'nt budget so I assumed it was gonna need a puller.

 

[davidf]

Thanks a million.:smile:

Here ya go.

http://www.nsxprime.com/forums/showthread.php?t=118741&highlight=studs
http://www.nsxprime.com/forums/showthread.php?t=116911

and here's a good DIY:

http://www.danoland.com/nsxgarage/fronthub/stud/studs.htm

HTH

 

[davidf]

Excellent. I remove the whole assm., not the hub.:redface: Again, thanks.