I need your help .... how I can remove the ext. window molding without to crack the plastic clips ....
thanks for your help
Raymond
thanks for your help
Raymond
remove the exterior window molding ?
- Thread starter Raymond-honda
- Start date
Could you be more specific as to which window and which mldg.
see on the pic ( parts sheet ) the part number 11 / 14 left & right exterior door window molding
how I can get out the clips of the molding .... with a special tool ?
It seems this is very difficult ....
how I can get out the clips of the molding .... with a special tool ?
It seems this is very difficult ....
Last edited:
I've had these off a couple times. Other than the one screw in the front, I did use a really small screwdriver the get it off the clips. No it was'nt easy as I'd liked but you'll need to start at the back {opposite end of the screw} and as you get each clip unhooked hold upward pressure on the moulding so it does'nt snap back in place.
I use 4 little screwdrivers.........
.........
Opp's, Larry is correct. I was thinking about the inner piece. :redface:
ok, thanks for your help ... I will try it and I hope to remove the molding without to damage them.
Took these page pics from my '94 NSX bible.:wink:View attachment 99047View attachment 99048=DREW=
- Joined
- 21 December 2005
- Messages
- 1,215
Pics don't work...
Shawn to the rescue. See post #5 in the following thread.
http://www.nsxprime.com/forum/showthread.php/179834-Removing-interior-door-panel
http://www.nsxprime.com/forum/showthread.php/179834-Removing-interior-door-panel
- Joined
- 21 December 2005
- Messages
- 1,215
Appreciate it.
Why are you doing this job, is there a replacement molding part that you are putting in? Thanks.
- Joined
- 21 December 2005
- Messages
- 1,215
Gonna wrap my car soon :wink:
Similar threads
