RC Engineering injector service help

[Hiroshima]

I did a few searches and came up with zip. Hopefully this is not rehashed:

I am about to send off my injectors for cleaning by RC Engineering. Here are some of my questions:

1. They said they provide new filters and o-rings. The injector has 3 bushings that I can tell. One under the mini-filter, the cushion bushing that looks kinda like an old wooden sewing spool, and a large thick o-ring that sits between the injector and the intake manafold.

Which ones do they provide and which ones do I have to buy on my own?

2. How hard is the install? I am sending off some used injectors that I purchased off of prime. The ones on my car are still installed. I have the factory manual but do you have any tips on installing my serviced injectors?

Thanks in advance

 

[DanO]

Here's a DIY www.danoland.com/nsxgarage/injector/injector.htm

The install isn't too bad if you have some experience. You do not need to replace the "wooden spool" rings. RC's injectors come with the o-ring and cushion ring. All you need to order is six of the 16472-PH7-003 seal ring. I'm writing this from memory so it might be a good idea to get a few more opinions before you start!

DanO