push-pin removal

[Tomrev]

Hi Prime; I'm pulling my fender liners tomorrow, and have struggled in the past saving the push clips. As I recall, you push on the center to remove, but this isn't working. Any hints, besides wasteing them all? I hate paying $2. each for the little dogs. Thanks, Tom

 

[NSXclear]

Push them in only slightly. DO NOT push them all the way through. Then take a flat head screw driver and pry them up from the outside circle.

You can buy new ones from here http://www.thefastenerwarehouse.com/catalog/item/568361/214758.htm. TR 126. They say nissan work on the NSX very well.

The are only $7.00 for 25 pcs and work very well. I bought the 100 pcs pack and replace the entire car.

They also work on the rubber molding that keeps the water out under the front hood near the windshield wipers.

 

[Tomrev]

Thanks vsy05, it's good to have a source for them. I think the one's I struggled with are goners anyway, so I can get all new. Tom

 

[NSXclear]

Your welcome, but I can't take credit for finding them. I'm just passing along the information I have found on Prime to other members.