Pics of my NSX in garage

Joined
15 July 2006
Messages
207
Location
Socal
Just a couple of pictures I took the other day while I was bored. I blame Erick for the Intake Manifold cover! :biggrin: Hopefully I will get the valve covers powdercoated to match.

nsxgarage2.jpg



nsxgarage.jpg
 
that valve cover looks nice... engine bay looks clean~!!!
 
Thank you for the comments everyone! When I get my valve covers powdercoated, I will update the pictures.


Very nice. Are you running wheel spacers? Rims look close to the edges of the fenders. Very clean for sure!!
I am running 15mm front/25mm rear wheel adapters lowered on Bilsteins (lower perch) with stock springs.
 
where are you getting them coated? and how long is the down time? cause i wanted to get mine done... so if you can find someone to do that matte wrinkle coat texture i'll maybe go in on it with you... :tongue:
 
I had a couple of feedback on shops to get the valve cover powdercoated. However, I was talking to Autowave earlier today and they mentioned a shop down the block that does powdercoating. Since my car will be at Autowave tomorrow getting some work done, they will see if the powdercoater can match the red/texture of the intake manifold cover. I will post the results later this week. I hope it goes well!

where are you getting them coated? and how long is the down time? cause i wanted to get mine done... so if you can find someone to do that matte wrinkle coat texture i'll maybe go in on it with you... :tongue:
 
Here is a update on powdercoating the valve covers red. I just finished talking to Autowave. Unfortunetely, the powdercoater down the block said it would be very hard/if impossible to match the same color/texture and that most likely it would be a brighter shade of red. Another shop said the same thing to me. Oh well, maybe if I can get my hands on a extra set of valve cover I will go ahead and ship it out to Science of Speed to get them done. For now, I think the black valve cover and red intake manifold cover looks good the way it is.
 
Here is a update on powdercoating the valve covers red. I just finished talking to Autowave. Unfortunetely, the powdercoater down the block said it would be very hard/if impossible to match the same color/texture and that most likely it would be a brighter shade of red. Another shop said the same thing to me. Oh well, maybe if I can get my hands on a extra set of valve cover I will go ahead and ship it out to Science of Speed to get them done. For now, I think the black valve cover and red intake manifold cover looks good the way it is.

bummer :frown:
 
Back
Top