I dont know if anyone has experienced this problem but has anyone ever tried taking out there axles but there just simply stuck to the rotor. I tried everything banging them with a hammer, hitting the rotor and it still wont come out my car is a 92.
NSX Axle's
- Thread starter NosNsx
- Start date
If the rotor has never come then there may be a couple of phillips screws holding it on. The screws are installed at the factory to keep the rotor on during assembly. These screws have to come out with an impact screwdriver.
DanO
NosNsx,
Please help me to understand a little better, you are trying to remove the axle shaft from the car, correct? DanO is right on about the rotor, but you did say "axle"??.
First thing is go to section 16 of the service manual on line here. Read through it, and see if you have any questions. I WOULD NOT separate the ball joints as described, just remove the lower control arm camber bolt and front bolt instead.
Right side of left??
HTH,
LarryB
Please help me to understand a little better, you are trying to remove the axle shaft from the car, correct? DanO is right on about the rotor, but you did say "axle"??.
First thing is go to section 16 of the service manual on line here. Read through it, and see if you have any questions. I WOULD NOT separate the ball joints as described, just remove the lower control arm camber bolt and front bolt instead.
Right side of left??
HTH,
LarryB
I had the same problem, beat the shaft with a hammer and it wouldn't budge. You will need an Air Hammer to push the shaft through the Hub unit.
Jonathan
Jonathan
