Reply to thread

I have the same hood and it's a VIS.

In the front corners, on the car frame, there're one each, a black rubber stop/cushion in each corner. If you get a grinder and remove a little of the height of the one on the r/s it will allow that corner of the hood to settle down a little. Most Hondas have them that have the ability to screw in but ours don't on the NSX. It should be what's holding it up in the front, anyway that's what was happening in my case. It sorted out pretty well. My trailing edge wasn't mis-aligned so I didn't have to worry there.


Cheers

nigel


Back
Top