Had an interesting issue recently where I went to unlock the doors with the (factory) keyless remote and the doors didn't unlock. Tried again, thinking that I must have forgotten to lock the car earlier, so it just now locked. Nothing. Tried the key in the cylinder. Nope.
Turns out the rod connecting the driver's side key cylinder to the lock assembly was hanging loose (luckily pass side lock cylinder still worked...). So I bought a new plastic clip to reattach it (#9 in the diagram below - P/N 72137-SS0-003). Easy, right?
Well, I can't figure out exactly how it's supposed to be attached. There are two parts to the clip - they can be folded relative to each other but are connected by plastic. The end with round ends obviously clips into the lock assy. But I'm not sure what to do with the back end. I thought it should be slid past the 90 degree angle in the lock rod, to keep the rod from pulling out of the clip (as pictured below). But when I do that, this back part of the piece seems to contact the part of the lock assy that the front part is supposed to plug into and prevents it from being able to be fully seated.
What am I missing? Couldn't find anything specific in the service manual on this.
Thanks,
Dave
<a href="http://s1318.photobucket.com/user/Dave2977/media/doorlockparts_zpsa4dac90f.jpg.html" target="_blank"><img src="http://i1318.photobucket.com/albums/t657/Dave2977/doorlockparts_zpsa4dac90f.jpg" border="0" alt=" photo doorlockparts_zpsa4dac90f.jpg"/></a>
<a href="http://s1318.photobucket.com/user/Dave2977/media/doorlockarrows_zpse8e307e2.jpg.html" target="_blank"><img src="http://i1318.photobucket.com/albums/t657/Dave2977/doorlockarrows_zpse8e307e2.jpg" border="0" alt=" photo doorlockarrows_zpse8e307e2.jpg"/></a>
Turns out the rod connecting the driver's side key cylinder to the lock assembly was hanging loose (luckily pass side lock cylinder still worked...). So I bought a new plastic clip to reattach it (#9 in the diagram below - P/N 72137-SS0-003). Easy, right?
Well, I can't figure out exactly how it's supposed to be attached. There are two parts to the clip - they can be folded relative to each other but are connected by plastic. The end with round ends obviously clips into the lock assy. But I'm not sure what to do with the back end. I thought it should be slid past the 90 degree angle in the lock rod, to keep the rod from pulling out of the clip (as pictured below). But when I do that, this back part of the piece seems to contact the part of the lock assy that the front part is supposed to plug into and prevents it from being able to be fully seated.
What am I missing? Couldn't find anything specific in the service manual on this.
Thanks,
Dave
<a href="http://s1318.photobucket.com/user/Dave2977/media/doorlockparts_zpsa4dac90f.jpg.html" target="_blank"><img src="http://i1318.photobucket.com/albums/t657/Dave2977/doorlockparts_zpsa4dac90f.jpg" border="0" alt=" photo doorlockparts_zpsa4dac90f.jpg"/></a>
<a href="http://s1318.photobucket.com/user/Dave2977/media/doorlockarrows_zpse8e307e2.jpg.html" target="_blank"><img src="http://i1318.photobucket.com/albums/t657/Dave2977/doorlockarrows_zpse8e307e2.jpg" border="0" alt=" photo doorlockarrows_zpse8e307e2.jpg"/></a>
Last edited:
