JIC FLT-A2 Adjustment

[Commander]

I have had the JIC FLT-A2 suspension installed for a while now. The more and more I look at the way the car sits though I wonder if it's too low in the front. So with this in mind, does anyone out there have this setup installed and if so could recommend what your height settings are?

What I have done is measured from the bottom side of the pillow mount to the top of the springperch collar then from the bottom of the springperch collar to the top of the lower adjustment collar. Settings currently are (with stock rims and tires / 16 Front 17 Rear -

Front - Springs Distance = 7.5 inches
Threaded Body Distance = 4.25 inches

Rear - Springs Distance = 7.5 inches
Threaded Body Distance = 3.75 inches

Lastely, I have ordered a set of Volk GT-V's in 18 Front and 19 Rear. Plan on installing 225/35/18 in the Front and 265(275)30/19 Rear unless someone has a better recommendation. Any setup for this particuliar set of rims and tires or should I not need to change anything.

Any and all advise would be greatly appreciated.

 

[brandonsan]

Measure the height of the front and rear jack / lift points. The height / distance should be equal. This will tell you if the front is sitting too low or not.

 

[vtecjulio]

Did you get those wheels yet? Did you measure the front and rear like suggested?