Jack contact points

There are two lift points on each side, where a metal bar is welded to the frame. One is behind the front wheel, the other is in front of the rear wheel. If you look beneath the car, you should be able to see them.
 
By the way, the floor is not capable of supporting weight. So don’t try and lift on anything other then the lift points as described.
 
So it looks like you cannot lift the entire front or back by placing the hydraulic floor jack under a central position, lifting up that end, and place jack stands at the two front or rear positions. Perhaps a 4-point lift is the best option.
 
There are a couple of stands that allow you to raise the car and then pull out the Jack. They are not cheap, about $200 per piece.
 
This is one example, the issue is getting under our cars as there is not a lot of space approximately 3 inches

The RennStand Jack Stand

www.ebay.com

The RennStand Jack Stand (18M-RS3) | eBay

Find many great new & used options and get the best deals for The RennStand Jack Stand (18M-RS3) at the best online prices at eBay! Free shipping for many products!
www.ebay.com
 
drmanny3 said:
This is one example, the issue is getting under our cars as there is not a lot of space approximately 3 inches

The RennStand Jack Stand

www.ebay.com

The RennStand Jack Stand (18M-RS3) | eBay

Find many great new & used options and get the best deals for The RennStand Jack Stand (18M-RS3) at the best online prices at eBay! Free shipping for many products!
www.ebay.com
Click to expand...
I've never seen that before, but its design makes sense. Thanks.
 

Similar threads

W
NEED HELP: Dropped wrench in engine bay
Replies
11
Views
376
Driver's Therapy
D
O
Minimum jack stand height to get all tires off the ground?
Replies
0
Views
57
optimist
O
G
Lifting NA1 NSX Up Off Its Wheels on 4 Post Car Lift?
Replies
16
Views
1K
FlopShot
FlopShot
S
HSC intake
Replies
2
Views
144
SoulC
S
Old Guy
Getting the Car up on Jackstands
Replies
13
Views
2K
Honcho
Honcho
Back
Top