I removed my air-cond

[menfou]

Hello,

I removed my Air Cond, but I would like to know something

I remove the bolt B on the picture, and after I removed the Adjusting pulley bracket, but I don't know if I must to put the bolt B again or not
I put the bolt B, but I am affraid with the parts A on the picture.
I don't want the parts A drop, and brake my engine

Do you understand what I mean ?


Thank you from Switerzland

 

[titaniumdave]

Put the bolts back in, will hold the spacers in place and seal the holes. Make sure the bolts don't bottom in the holes with out the adjuster in place, you might want to put a couple of washers in place to replace the thickness of the adjuster, just to be on the safe side.

 

[Larry Bastanza]

I understand your question.

I would reinstall the two "B" bolts. I would remove the pulley assembly and use washers to make up the thickness of the pulley bracket, or disassembly the pulley assembly and only install the bracket. I say this because I am not sure how deep the threads are in the bosses on the engine block for the two "B" bolts.

A few washers are lighter in weight.

HTH,
LarryB