Help please installing my scienceofspeed center console.

[seeknsx]

Hi everyone,

I just buy a new center console from a prime member and they did not come with the instructions on how to install the coin tray and the shift boot, the console is the one that scienceofspeed sell, someone help me please.


Thanks.

 

[JoseJA1979]

contact SOS...i'm sure they'll give you/send you instructions.

 

[seeknsx]

Hi Jose,
I already send him an mail and I still have no response from them.:frown:

contact SOS...i'm sure they'll give you/send you instructions.

 

[JoseJA1979]

The boot and coin tray are secured with epoxy or silicone adhesive (only a very small amount is required). This actually works really well. We've looked into glassing in metal brackets, however, the result has not been satisfactory.

-- Chris

http://www.nsxprime.com/forum/showthread.php/150809-SOS-Composite-Center-Console/page2?p=1461661&viewfull=1#post1461661

 

[seeknsx]

Thanks Jose for your reply, I appreciate :biggrin:

 

[nsxter]

If the console does not have the mounting posts installed, you will need to fabricate them, and epoxy them in the correct locations on the console. then the shift boot and coin tray will screw to the posts.
You can see how they are screwed to the console in the second pic here: http://www.nsxprime.com/forum/showt...le-Double-Din?highlight=coin+tray+screws+post

Or silicone them in...not my favorite way

 

[seeknsx]

Hi nsxter thanks for your reply,
Yes I prefer not to use silicone I feel that it will fall off.
regards

If the console does not have the mounting posts installed, you will need to fabricate them, and epoxy them in the correct locations on the console. then the shift boot and coin tray will screw to the posts.
You can see how they are screwed to the console in the second pic here: http://www.nsxprime.com/forum/showt...le-Double-Din?highlight=coin+tray+screws+post

Or silicone them in...not my favorite way

 

[Ramirez428]

Abs rods. Order a few online (thick enough for a screw) easy to cut and file down to the proper angle. You can drill the center of them so you can use oem screw's.

I would cut like a 1" inch piece's & drill a hole out in the center. Mount the piece's to the items (shift boot & coin tray). Start fitting the piece's from behind, just cut away & file down the abs rod's until it sits nice and flush to the console.

Once you have each rod at the proper length and angle use some plastic epoxy between the rod end and console. Once its all dry the rods will have dried perfectly in place. you'll be able to remove/mount those items just like oem using oem screws.

Hopefully that makes sense lol.