Front camber kit install

[asylum]

I just received the Comptech front camber kit. This consist of 4 large and 4 thin bushings.

I want to increase my front negative camber (going from -2° to -3° and more), In order to be sure of the installation :

- they go on the lower arm ? Nothing to change on the upper arm ?
- I have to press the stock bushings out and install the Comptech ones so that the non-centered holes are at the inner side of the bushing (inner = center of the car) ?

Thanks.

 

[Larry Bastanza]

If you want more negative camber, the lower part of the wheel is further OUT and the top is further IN, so the holes in the LOWER bushings should be further AWAY from the centerline of the car.

And yes, the upper does not change, since the ball joint is a permanent part of the upper arm and has no removable bushing.

HTH,
LarryB