Exhaust fitment question

[mmerical]

Greetings,

I had the chance today to install my newly acquired Taitec GTLW on my '92 and overall am very happy. The install was very straightforward and only took about 20 minutes from start to finish. However, once installed I noticed the exhaust is not sitting in the proper location.

If you're looking at it from the rear of the car it needs to shift about 1 or 2 inches towards the drivers side(not centered in the opening of my '02 rear valence). I've installed a few multi-piece exhaust systems before and have run into fitment problems that I was able to remedy via adjustment but am unsure how to approach this as it's one piece. Does anyone have any recommendations?

thanks,

Matt

 

[docjohn]

Not exactly related to the gtlw but there are some good tips in general about adjusting exhausts hope it helps http://www.nsxprime.com/forums/showthread.php?s=&threadid=15953&highlight=tubi+install

 

[mmerical]

Good evening,

Thanks for the link. I've been searching through older posts without much luck. I'm going to recheck the rubber isolators to make sure they're all seated properly just to be safe. It's just odd that everything fits well, just is sitting too far to the right.

Matt