DIY: Stanceparts Air Cup Kit (91-05)

[Chris_Lum]

This video is a long detailed video meant to walk you through a step by step installation of the Stanceparts cup kit on a 91-05 Acura/Honda NSX. This is using Stanceparts cups with a 1.5Gal Viair tank/compressor combo. Modifications I've added to the factory setup are: Electronic Purge Valve and switched compressor and purge valve. This is for a 2 cup setup and front mounted tank, however it will work the same with the tank mounted in the trunk, you will just have to use longer wires and possibly thicker gauge wires due to the added length.

Parts Used in this video:
-Stanceparts cups (Sized for KW V3 Shaft)
-Viair 1.5Gal Tank/Compressor Combo
-KW V3 140mm length front springs
-Electronic Drain/Purge Valve (1 required): https://a.co/1GmeZe7
-90-degree elbow fitting for Purge Valve (1 required): https://a.co/15d8e3Y
-Blue LED Push Button Switch (1 required): https://a.co/g9JXUjG
-3 Position Rocker Switch (1 required): https://a.co/cpQQnMK
-Add a Circuit Fuse Tap (1 required): https://a.co/53SbsI1
-40A 4 pin Relay (1 required): https://a.co/9yk35iE

For Wiring Harness:
-2 Pin Weather Sealed Connectors (1 required): https://a.co/aLscGNu
-3 Pin Weather Sealed Connectors (2 required): https://a.co/fIGYotY
-4 Pin Weather Sealed Connectors (1 required): https://a.co/dsiK8dj
-3/4" OD, 1/4" ID, 3/8" thick spacers (2 required): https://a.co/7mOGep8
-Braided Wiring Loom: https://a.co/eDwRWXo
-T-Taps, Male/Female spade connectors, Ring terminals, 16 AWG wiring as needed for the harness.
-Terminal DIY Kit: https://a.co/384fyDR

0:00 - Cup Kit Components
6:30 - Wiring Diagram
11:30 - Assembly
16:45 - Running Wire To Cabin
22:24 - 12V & Acc Power
12:12 - Switch Plate Fabrication
27:45 - Cup Installation & Assembly
37:07 - Routing Air Lines
43:01 - Air Line Lengths
43:50 - Mounting 3 Way Valve
44:42 - Mounting the Tank
52:46 - Final Connections
54:43 - Button Functionality
1:00:52 - Cups in Action