changing bulbs for parking light???

[nis350]

How to change the bulbs for the front parking light on the bumper on the passenger side? Instructions please...

Thanks.

 

[loNfastNSX]

First you will need a long phillips head screw driver. find the hole on the underside of the front bumper, right under the inside side of the parking lights/ turn signal. Take the screw out but be careful, there is a small plastic piece in there that can be broken. Its easy to do. After you remove the screw, carefuly pry out the lens. You should be able to figure the rest out. Just replace the bulb and put everything back. DO NOT tighten the screw back TOO HARD!!! The plastic tab will crack under the presure. Tighten till firm but thats it. GOOD LUCK.

 

[nis350]

First you will need a long phillips head screw driver. find the hole on the underside of the front bumper, right under the inside side of the parking lights/ turn signal. Take the screw out but be careful, there is a small plastic piece in there that can be broken. Its easy to do. After you remove the screw, carefuly pry out the lens. You should be able to figure the rest out. Just replace the bulb and put everything back. DO NOT tighten the screw back TOO HARD!!! The plastic tab will crack under the presure. Tighten till firm but thats it. GOOD LUCK.

Are these screws inside of the air scoop? How many are there? Does the whole parking/signal assembly come off or just the lens?

Thanks.

 

[Forums Nazi]

This has been previously covered here lots of times. Do a search and you should be able to find all the previous topics.

 

[loNfastNSX]

damn, you got nazied...

There is only one screw for each assymbly and it is in the air scoop. The whole lens/assembly will come out. Its really easy once you get into it. You should have no problems.

 

[nis350]

damn, you got nazied...

There is only one screw for each assymbly and it is in the air scoop. The whole lens/assembly will come out. Its really easy once you get into it. You should have no problems.

Done. Thank you.

 

[Evoking]

I'm trying to do this but I cannot see the screw up through that little hole. Also, won't you loose the screw after you screw it out? I've got to go buy a long phillips but I'm still not seeing how this can be done so easily.

Also, when I go get bulps can I get a higher wattage?

 

[KGP]

No, you won't lose the screw. Get a flashlight and look up in the hole. Like you, I assumed I didn't have a long enough screw driver. It's an angle type of thing. Once you see the screw, you will not have a problem. :smile: