BEST way to thread wires through the front firewall?

[EuroBoutique]

I do not want to drill any holes so just wondering if there are any factory grommets so I can run a few wires from the hood area to the interior compartment?


thanks in advance

 

[acuratech27]

you can poke a small hole in the rubber wiring grommet on the passenger side and feed them through there

 

[93nsx]

you can poke a small hole in the rubber wiring grommet on the passenger side and feed them through there

Also, best way to do this is get a metal coat hanger usually from a dry cleaning place, then cut it to where you can bend it into a stick. Sharpen one end to a point, tape the wire to the dull end, feed the coat hanger through the rubber grommet(careful not to poke any electrical wires). Basically its like sewing. Hope this helps

 

[EuroBoutique]

thanks guys for the tips - I will try to tackle this job tonight


appreciate it!

 

[nsxter]

On the drivers side, there is a grommet right above the clutch pedal arm, just poke thru it.

 

[jcsb]

I've used both of these very successfully.
John
http://www.amazon.com/gp/product/B000K1IEAC/ref=oss_product
http://www.amazon.com/gp/product/B002LE8CQM/ref=oss_product

 

[EuroBoutique]

thank you guys for all the advice and help!

I used the coat hanger trick and it worked perfectly ~ hardest part was to find an actual metal coat hanger around the house...haha

 

[DocL]

As always, great advice given here on Prime.

However, don't you remember what mother said: "No wire hangers!". :biggrin: