91 Remote entry install questions

[JD Cross]

I have a 91 with an OEM remote system part #08E60-SLO-200 bought from Niello Acura in 2002.
Some reading I've done suggest this remote won't work on a 91??

In my installation 2 wires, a red and a yellow need to be inserted into an existing 16 pin block.

Problem # 1
I can't get the terminal block out of it's base. The block is unlocked - any suggestions here?

Problem #2
The terminal end to the yellow wire has broken off and needs to be replaced
Does anyone know where to get the correct terminal end for this wire?

Thanks
Jim

 

[shawn110975]

heres my thread when I solved all of the issues, read up.

http://www.nsxprime.com/forums//showthread.php?t=140311

those 2 wires that you plug into the second grey harness do nothing on the 1991-1992.

the only wires you need to connect are the

pin 9 on the left harness and pin 1 on the right harness both plug into the SCU( security control unit )

I had all the service manuals in front of me and found that these wires do nothing.

I started selling the kits that adapt the new brains to fit into the 1991-1992 harness. read my post and if you need more help PM me

prob 1 a great trick is to unlock the pigtail, then pull the wire out. if it will not budge then use a flathead screwdriver and press from the front of the pin you need removed intill it wiggle enough for you to pull it out from the back.

prob 2 I have those ends you need. you would need to open the locking mech on the plug, attach the wires with crimps or electric tape, then slide my new END into the main housing and click it closed and lock.
if you need them let me know I have lots of them sitting in a box