Removing rear bumper ?

Sandro · 20 March 2010

I'm doing something custom on rear bumper.It would be bottom half completely
different whit new diffuser,to put it on need to remove rear bumper.Please some instruction for easier removing.
Thanks!

grybrd · 20 March 2010

Fold the trunk floor trim panel forward and remove the two bumper mounting nuts.
Remove the bumper mounting nuts on each side from under the trunk floor.
Lower the inner fenders.
Remove the under covers and skirt mounting bolts from inside the rear fender on each side.
Remove the two bumper mounting nuts on each side.
Remove the bumper assembly by sliding it to the rear.
Disconnect the license light connector.
(From the service manual, page 20-49)

pegi · 20 March 2010

... When you start to do this, u will see then how easy it will be to take it off

Sandro · 20 March 2010

Thanks for advice bumper is all ready down.
:wink:

pegi · 21 March 2010

Sandro said:
Thanks for advice bumper is all ready down.
:wink:

Nice to hear

!
It wasn't difficult at all, right

?

Sandro · 21 March 2010

pegi said:
Nice to hear !
It wasn't difficult at all, right ?

I don't have the manual so it's easier when you know were are bolts.
Sun I will post pics of aero pack on what I'm doing(on another thread)front and
rear bumper and side skirts.

Racerxjling · 21 March 2010

Sandro said:
I don't have the manual so it's easier when you know were are bolts.
Sun I will post pics of aero pack on what I'm doing(on another thread)front and
rear bumper and side skirts.

I know you already have it done but here is a good link for others

http://www.nsxprime.com/forums/showthread.php?t=105405&highlight=bumper

A.S. Motorsport · 28 March 2010

Here you go, Hope it helps.

Removing rear bumper ?

Similar threads